Electric Vacuum Pump with Connector Interface
Electric Vacuum Pump with Quick Connect Terminals
Designed to supplement diesel engines in controlling heat-
ing and cooling functions, door locks, cruise controls, trunk
release or any other functions controlled by vacuum.
• 12V DC
Sealed motor (inlet port, outlet and pump end)
Environmentally tested; humidity, salt, fog dust, air and
Meets on (1) meter (3.28 feet) drop test
Electrical Terminals: meet axial force (push/pull) of
Vibration tested: eight (8) hours per plane; amplitude
(peak to peak) 1.27 mm (0.05 in.)
Electrical Stress Tested; Load Dump, Reverse Voltage,
Short to Power Ground, non-disruptive transients and
•Meets standard corrosion test ASTM-B 117
•Temperature Range: -25°C to +96°C
•Weight: 13 grams (11 oz.)
50/50 water, ethylene glycol antifreeze
Dexcon II transmission fuid
Leaded or unleaded regular gasoline
Dot 3 hydraulic brake fuid
Ethanol, 25% methanol +5% liquid soap
Evacuate a 40 cubic inch (minimum) reservoir from
atmoshere pressure to 15 inches of mercury vaccum in
maximum of 20 seconds.
Internam switch turns motor off when the vacuum reach-
es a maximum of 15 inches of mercury. When vacuum is
reduced to a minimum of 11 +2 or -0 inches of mercury
switch will reactivate motor to increase vacuum.
Motor draws no more than .65 average amperages with
13.5V applied to pump terminals.
Type 1: Connector Interface
Electrical connector supplied through Packard.
Female Terminal 18-20 gauge 12048074
Type 2: Quick Connect Terminals
6.3 mm (.250”) female quick connect terminal
Hella part number 701235033 or 701235034 (order 2 per